Mitsubishi Electric MELFA CR800-D Series - MELFA Robot Language Specification

10
3.3. Hardware of the CC-Link Interface Card
This section describes the settings that are performed by using the rotary switches and DIP switches on the
CC-Link interface card.
3.3.1. Card overview
(1) General Layout of the Card
Figure 3.3-1 General Layout of the Card
3.3.2. DIP switch
There are the three DIP switches (SW1 / SW2 / SW3) on the CC-Link interface card (TZ576).
The item which can be set up with each DIP switch is shown in the following.
Table 3.3-1 Function of DIP switch (SW1)
Switch OFF ON
Factory
setting
Description
SW1
1
ON (fixation)
ON
2
Ver.1 mode Ver.2 mode ON
Specify the version of CC-Link.
In case of the Ver.2 mode, the
extended cyclic setup is possible.
3
OFF (fixation)
OFF
4
OFF (fixation)
OFF
ＬＥＤ
CC-Link cable
connection connector
DIP switch（SW1/SW2/SW3）