Mitsubishi Electric MELSEC-L Series - Parameter Setting

130
12.5 Parameter Setting
Set the following parameters to perform communications using a fixed buffer.
• Basic setting ( Page 66, Section 7.1.2)
• Ethernet operation setting ( Page 67, Section 7.1.3)
• Open setting ( Page 69, Section 7.1.4)
Item Description Setting range
Fixed Buffer
Select whether to use the fixed buffer for connection with the connected device for
sending or receiving.
• Send
• Receive
Fixed Buffer
Communication
Select the communication method for communications using a fixed buffer.
• Procedure Exist
• No Procedure
Pairing Open
Select whether to disable or enable the pairing open for communications using a
fixed buffer.
( Page 139, Section 12.7)
• Disable
• Enable
Existence Confirmation
Select whether or not to use the alive check function. ( Page 194, Section
14.7) Select "No Confirm" to send data by broadcast communications during "No
Procedure" communications using a fixed buffer.
• No Confirm
• Confirm