206
15.7 GP.ECPRTCL
This instruction executes the protocols registered in the flash ROM of the E71 using the predefined protocol support
function of GX Works2.
*1 The file registers set for each local device and program cannot be used.
(1) Setting data
Setting data
*1
Available device
Internal device
(system, user)
File
register
Link direct device
J\
Intelligent
function module
device U\G
Index
register
Zn
Constant
Others
Bit Word Bit Word K,H $
n1
n2
(S)
(D)
Setting data Description Set by Data type
Un
Start I/O number of the E71 (00 to FE
H
: The first two digits
of the three-digit I/O number)
User
BIN 16-bit
n1 Connection number (1 to 16)
BIN 16-bit
Device name
n2 Number of consecutive protocol executions (1 to 8)
BIN 16-bit
Device name
(S) Start number of the device that stores control data User/system Device name
(D)
The start number of the bit device in the own station that
turns on for one scan upon completion of the instruction.
(D)+1 also turns on if the instruction ends abnormally.
System Bit
GP.ECPRTCL
Command
GP.ECPRTCL Un n1 n2 (S) (D)
To Next Page
Loading...
