64
CHAPTER 7 COMMUNICATION PROCEDURE
This chapter describes the procedure for communicating with connected devices after the E71 is connected to
Ethernet. For the procedure for connecting the E71 to Ethernet, refer to "PROCEDURES BEFORE OPERATION".
Continued from PROCEDURES BEFORE OPERATION
( Page 55, CHAPTER 4)
Page 65, Section 7.1,
Parameter setting of each function
MELSEC-L CPU Module User's
Manual (Hardware Design,
Maintenance and Inspection)
Page 72, Section 7.2,
Page 79, Section 7.3
Page 72, Section 7.2,
Page 79, Section 7.3
Parameter settings
Set the parameters (excluding the basic setting and Ethernet operation
setting) if necessary.
Starting the CPU module
Reflect the parameter settings by turning off and on the CPU module or
resetting the CPU module.
Initial process
The initial process of the E71 is automatically performed.
The open process is to establish a connection with a connected device.
Open process
Data communications using
each function
Close process
The close process is to disconnect (cancel) the connection with the
connected device established by the open process.
To Next Page
Loading...
