Mitsubishi Electric MELSEC-L Series - Program Example

179
CHAPTER 14 OTHER FUNCTIONS
14
14.3 IP Filter Function 14.3.3 Program example
14.3.3 Program example
The following is a program example that allows access only from the IP addresses 192.168.3.1 to 192.168.3.5. (When
the I/O signals of the E71 are X/Y00 to X/Y1F)
(1) Sample program
Set the IP filter function to "Use".
Set the end IP address to "192.168.3.5".
Set the start IP address to "192.168.3.1".
Set "Allow".