55
CHAPTER 4 PROCEDURES BEFORE OPERATION
4
CHAPTER 4 PROCEDURES BEFORE OPERATION
This chapter describes how to connect an E71 to Ethernet. For how to communicate with connected devices after the
E71 is connected, refer to the communication procedure. ( Page 64, CHAPTER 7)
Page 27, CHAPTER 3,
Page 57, CHAPTER 5
Page 25, CHAPTER 2,
Page 61, Section 6.1
Page 58, Section 5.2,
Page 62, Section 6.2
Page 66, Section 7.1.2,
Page 67, Section 7.1.3
MELSEC-L CPU Module User's
Manual (Hardware Design,
Maintenance and Inspection)
Page 322, Appendix 5
Continued to COMMUNICATION PROCEDURE ( Page 64, CHAPTER 7)
Checkbox
Design the system configuration of the E71.
System consideration
Installation
Connect the E71.
Wiring
Connect an Ethernet cable to the E71.
Setting parameters
Set the following parameters, which are required to start up
the E71, from the programming tool.
Basic setting
Ethernet operation setting
Restarting the CPU module
Reflect the parameter settings by turning off and on the CPU
module or resetting the CPU module.
Network diagnostics
Check that the cables are connected properly or that
communications are performed properly with the set
parameters. (PING test, loopback test)
To Next Page
Loading...
