62
6.2 Wiring
This section describes Ethernet cable wiring and wiring precautions. For a network configuration and cables and hubs
used, refer to "SYSTEM CONFIGURATION". ( Page 57, CHAPTER 5)
(1) Ethernet cable connection
The following is how to connect and disconnect an Ethernet cable.
(a) Connecting the cable
(b) Disconnecting the cable
1. Power off the E71 and the connected device.
2. Push the Ethernet cable connector into the E71 until
it clicks. Pay attention to the connector's direction.
3. Power on the E71 and the connected device.
1. Power off the system.
2. Press the latch down and unplug the Ethernet cable.
To Next Page
Loading...
