173
CHAPTER 14 OTHER FUNCTIONS
14
14.1 Router Relay Function
14.1.2 Parameter settings
(b) Router IP address
Set the IP addresses of the routers when the E71 communicates with the connected devices on other Ethernet
networks via a router other than the default router. Set the value that satisfies the following conditions.
• Condition 1: The IP address class is any of A, B, and C.
• Condition 2: The subnet address of the router is the same as that of the E71 on the own station.
• Condition 3: The host address bits are not all "0" or all "1".
● When the E71 communicates with the connected devices via a router in Passive open status, communications can be
performed without using the router relay function.
● The router relay function is not needed in a system that uses the Proxy router.
To Next Page
Loading...
