325
APPENDICES
A
Appendix 5 Line Status Check
Appendix 5.1 PING test
(2) Performing a test with direct connection to the CPU module
This test is to check the existence of an E71
*1*2
, that has completed the initial process on the same Ethernet
network where a station connected to the programming tool exists or to check the existence of a connected
device, such as a personal computer, having a specified IP address, by directly connecting the programming tool
and the CPU module.
*1 This also applies to Q/QnA/A series modules. However, for an AJ71E71, AJ71E71-B2, and AJ71E71-B5, software
versions S and later are required.
*2 The PING test cannot be executed on the own station.
(a) Applications
By specifying the execution station and the target station, the PING test can be executed from a remote device.
(b) Operating procedure
Use the following procedure.
1. Click the button in the "Ethernet
Diagnostics" window.
[Diagnostics] [Ethernet Diagnostics]
"Target Module Setting" under "Module No."
Ethernet
E71
PING test executing station
Specifying the station
executing the test
using the network No.
and station No.
(PING test target station)
Specifying the target station
using the IP address
Programming tool
CPU module
To Next Page
Loading...
