2 - 74
2 SYSTEM CONFIGURATION
CAUTION
Do not short a battery.
Do not charge a battery.
Do not disassemble a battery.
Do not burn a battery.
Do not overheat a battery.
Do not solder the battery terminal.
The data (Refer to Section 6.5.) in the RAM built-in Motion controller is not backed up without
using the battery.
(3) Connection procedure with Motion controller
Set the battery (Q6BAT/Q7BAT) to the battery holder, and connect the lead
connector of battery to the battery connector of Motion controller.
Put the lead wire in the battery holder, and set it to the Motion controller.
PUSH
Motion controller
Battery holder
Refer to Section 4.1.4 for the mounting and removal of the battery holder and the
connection of the battery lead wire.
To Next Page
Loading...
