5 - 7
5 START-UP PROCEDURES
5.3 Operating System Software Installation Procedure
The operating system software must be installed to the Motion controller by using the
peripheral device and MT Developer2.
The installation procedure is shown below.
Turn ON the Motion controller's power
supply.
Set a rotary switch1 (SW1) of Motion
controller to "A".
(Rotary switch 2 (SW2) is optional.)
Set the connection method between
the personal computer and Motion
controller in the Transfer Setup.
Turn OFF the Motion controller's
power supply.
Set a rotary switch1 (SW1) and
switch2 (SW2) of Motion controller to
"0".
Start the install of MT Developer2.
Dialog "Installation is completed" is
displayed.
The operating system software can be
installed normally by dialog display.
Operation in
MT Developer2
(Note)
START
Set to installation mode.
Refer to Section 2.5.1(6) for rotary switch.
Steady "INS" display.
RUN/STOP is ignored.
Set to mode operated by RAM.
END
(Note): Install the operating system software by screen of MT Developer2.
Refer to help of MT Developer2 for details.
Switch setting of factory default
SW1 "0", SW2 "0" position
Select the operating system software
installed, and install it in the Motion
controller.
Only when the operating system software
(SV22) is installed, select one of the
following operation methods.
Virtual mode switching method
Advanced synchronous control method
To Next Page
Loading...
