5 - 8
5 START-UP PROCEDURES
POINTS
(1) When the software security key function is used in Motion controller, if the
software security key of the operating system software already installed in
Motion controller is different from that embedded to the operating system
software to be installed, "Clear all" is executed at installation. It is
recommended to backup the data in advance using MT Developer2.
(2) The operating system software (SV22 (Virtual mode switching method)) is
installed at the time of product purchase.
(3) The operating system software is installed to the Motion CPU area. It has
already been installed to the PLC CPU area.
The PLC CPU area is never rewritten.
(4) Be sure to turn power supply OFF before changing rotary switch setting.
(5) Even if the operating system software is installed, the programs, parameters
and absolute position data written in the Motion controller not rewritten.
(6) Do not do any of the following while installing operation system software.
Doing so could result damage the Motion controller.
• Turn OFF the Motion controller's power supply.
• Change the RUN/STOP/RESET switch of Motion controller to RESET.
• Turn OFF the power supply of the personal computer.
• Pull out the personal computer's communication cable.
(7) Only when the operating system software (SV22) is installed on the Motion
controller, select one of the following operation methods.
• Virtual mode switching method
• Advanced synchronous control method
To change the operation method after the operating system software is
installed, install the operating system software (SV22) again, or change the
operation method in "Change CPU operation method" of MT Developer2.
Refer to help of MT Developer2 for details.
To Next Page
Loading...
