Mitsubishi Electric Q170MSCPU-S1 - Page 137

4 - 14
4 INSTALLATION AND WIRING
(2) Battery holder (For Q6BAT)
(a) Mounting
Motion
controller
Battery holder
Battery holder
3)
Battery connector
(Q170MSCPU side)
Battery lead
connector
(Battery side)
Installation grooves
Push
1)
2)
Lead wire fixing hook
2)
Connect the battery lead connector
to the battery connector.
3)
END
Make sure that the battery holder
is installed in the Motion controller
securely.
Adjust the battery holder to the
installation grooves, and slide the
battery holder in the direction of
the arrow, taking care to not
damage the lead wires.
(Be sure to insert it until it clicks.)
Anchor the lead wire to the lead
wire fixing hook.
1)