Mitsubishi Electric R60AD8-G - Page 154

152
APPX
Appendix 3 Buffer Memory Areas
Interrupt factor mask [n]
Set Interrupt factor mask to be used.
When 'Interrupt factor mask [n]' (Un\G124 to Un\G139) is changed to Mask clear (Interrupt used) (1) and an interrupt factor
occurs, an interrupt request is sent to the CPU module. When the set value is two or larger, the setting is regarded as Mask
clear (Interrupt used) (1).
"n" indicates an interrupt setting number. (n = 1 to 16)
■Buffer memory address
The following shows the buffer memory address of this area.
■Default value
The default value is set to Mask (Interrupt unused) (0) for all channels.
Interrupt factor reset request [n]
An interrupt factor reset request is sent.
When Reset request (1) is set to 'Interrupt factor reset request [n]' (Un\G156 to Un\G171) corresponding to the interrupt factor,
the interrupt factor corresponding to the specified interrupt is reset. After that, 'Interrupt factor reset request [n]' (Un\G156 to
Un\G171) turns to No reset request (0). When the set value is two or larger, the setting is regarded as Reset request (1).
Interrupt factors can be reset by turning on and off 'Operating condition setting request' (Y9).
"n" indicates an interrupt setting number. (n = 1 to 16)
■Buffer memory address
The following shows the buffer memory address of this area.
■Default value
The default value is No reset request (0) for all channels.
Setting value Setting content
0 Mask (Interrupt unused)
1 Mask clear (Interrupt used)
Buffer memory name 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Interrupt factor mask [n] 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139
Interrupt factor mask [n] (in Q
compatible mode)
4032 4033 4034 4035 4036 4037 4038 4039 4040 4041 4042 4043 4044 4045 4046 4047
Setting value Setting content
0 No reset request
1 Reset request
Buffer memory name 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Interrupt factor reset request
[n]
156 157 158 159 160 161 162 163 164 165 166 167 168 169 170 171
Interrupt factor reset request
[n] (in Q compatible mode)
4064 4065 4066 4067 4068 4069 4070 4071 4072 4073 4074 4075 4076 4077 4078 4079