200
APPX
Appendix 3 Buffer Memory Areas
CH1 Offset/gain setting mode
Specify the channel where the offset/gain setting is adjusted.
• Offset/gain setting mode (offset specification): Channel to adjust the offset
• Offset/gain setting mode (gain specification): Channel to adjust the gain
Set one of the offset specification or gain specification to the Setting channel (1), and the other to Disable (0). When a value
other than 0 and 1 is set, an offset/gain setting channel range error (error code: 1E8H) occurs.
Multiple channels can be set at the same time. In that case, set the offset specification and gain specification separately. The
offset specification and gain specification cannot be set at the same time.
In the following cases, an offset/gain setting channel specification error (error code: 1E50H) occurs.
• When both the offset specification and gain specification of the same channel are set to Setting channel (1)
• When Disable (0) is set for all channels
• When both the offset specification and gain specification of multiple channels are set to Setting channel (1) at the same
time
■Buffer memory address
The following shows the buffer memory address of this area.
•CH Offset/gain setting mode (offset specification)
•CH Offset/gain setting mode (gain specification)
■Enabling the setting
Turn off and on 'Channel change request' (YB).
■Default value
The default value is Disable (0) for all channels.
Setting Setting content
0 Disable
1 Setting channel
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 CH12 CH13 CH14 CH15 CH16
4132 4134 4136 4138 4140 4142 4144 4146 4148 4150 4152 4154 4156 4158 4160 4162
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 CH12 CH13 CH14 CH15 CH16
4133 4135 4137 4139 4141 4143 4145 4147 4149 4151 4153 4155 4157 4159 4161 4163
To Next Page
Loading...
