Mitsubishi Electric R60AD8-G - Page 255

10 FUNCTIONS
10.1 SIL2 Mode
253
10
Setting parameters on the SIL2 Process CPU side
With the created project, set the parameters.
1. Set "CPU Parameter" according to the system configuration.
For details on item and setting procedure, refer to MELSEC iQ-R CPU Module User's Manual (Application).
2. Set "Required Settings" in "Module Parameter" for the master/local module.
[Navigation window]  [Parameter]  [Module Information]  Ta rge t modu l e  [Module Parameter]  [Required
Setting]
3. Using "Network Configuration Settings" in "Module Parameter" for the master/local module, set the intelligent device
station. For the intelligent device station, set RJ72GF15-T2 or RJ72GF15-T2 (LR) depending on the system
configuration.
[Navigation window]  [Parameter]  [Module Information]  Target module  [Module Parameter]  [Basic Settings]
 [Network Configuration Settings]
4. Set "Refresh Setting" in "Module Parameter" for the master/local module as shown below.
[Navigation window]  [Parameter]  [Module Information]  [RJ71GF11-T2]  [Module Parameter]  [Basic setting]
 [Refresh settings]
5. Save the project.