Mitsubishi QD70P4 - Section 2 Control Details and Setting

SECTION 2 CONTROL DETAILS AND SETTING
Section 2 is configured for the following purposes shown in (1) to (3).
(1) Understanding of the operation and restrictions of each control.
(2) Carrying out the required settings in each control
(3) Dealing with errors
The required settings in each control include parameter setting, positioning data setting,
control data setting by a sequence program, etc.
Carry out these settings while referring to "CHAPTER 4 DATA USED FOR POSITIONING".
Also refer to "CHAPTER 7 SEQUENCE PROGRAMS USED IN POSITIONING CONTROL"
the sequence programs required in each control, and consider the entire control program
configuration when creating each program.
CHAPTER 8 OPR CONTROL .............................................................................................8- 1 to 8- 16
CHAPTER 9 POSITIONING CONTROL.............................................................................9- 1 to 9- 17
CHAPTER 10 JOG OPERATION.......................................................................................10- 1 to 10- 6
CHAPTER 11 SUB FUNCTIONS ......................................................................................11- 1 to 11- 13
CHAPTER 12 COMMON FUNCTIONS..............................................................................12- 1 to 12- 3
CHAPTER 13 TROUBLESHOOTING ...............................................................................13- 1 to 13- 14
SECTION 2