IPB-5000A
6. Discription of Display Screens
6-19
(f) NO CURR MONITOR START
Set the starting time (Period for Neglect) of no-current supplying monitor.
No-current supply is not detected during the Period for Neglect from the
start of current supply.
(g) PW MONITOR START
Set the starting time (Neglect) of pulse width monitor.
No pulse width monitor is performed during the Neglect period from the
start of current supply.
(h) NG OUTPUT
Set the mode of NG terminal.
NORMALLY CLOSE : Open at the occurrence of NG.
NORMALLY OPEN : Closed at the occurrence of NG.
(i) READY OUTPUT
Select the mode of READY terminal.
WELD ON : Ready at Weld On
POWER ON : Ready at Power On
(j) ERROR
Displays ③ ERROR SETTING Screen.
(k) MISC
Displays ④ MISC Screen.
(l) PREV
Displays ① STATUS(1/2) Screen.
To Next Page
Loading...
