Miyachi IPB-5000A - Rear Panel

IPB-5000A
4. Name and Functions of Each Section
4-3
(2) Rear Panel
① Connecting Terminal Strip for External Input/Output Signal
Used for inputting the schedule signals, outputting trouble signals, etc.
The size of screws is M3.5 for connection.
② Breaker for Welding Power Input
Used to accept three-phase power supply for welding.
The size of screws is M5 for connection.
③ Lever for Welding Power Input Breaker
Pulling up the Lever supplies power; pushing down disconnects power supply.
④ Welding Transformer I/O Signal Connector
Used for connecting [SENS] cable of welding transformer manufactured by
Miyachi Corp.
⑤ Terminal Block for Welding Power Output
Used for connecting to the input of welding transformer.
The size of screws is M6 for connection.
①
②
③
④
⑤
Input Breaker Cover
【Terminal Cover Installed】
Rear Panel
Input/Output Terminal Cover
Output Terminal Cover
【Terminal Cover Removed】
I/O
RS232C/RS485
11 37353331292725232119171513975
383634323028262422201816141210864
STOP
1ST
2ND
COM
SCH 1
SCH 4
SCH 8
SCH16
SCH32
SCH 2
SCH64
INT.24V
EXT.COM
WELD ON/OFF
ERROR RESET
COM
COM
GOOD
NG
END
CAUTION
COUNT UP
READY
OUT COM
OUT COM
SOL 1
SOL 2
SOL COM
PRG PROTECT
39
PARITY
(WE1 STOP)
COM
W.INTERRUPT
P-00281-001
COUNT RESET
CONTROL SIG
2
31
(OPTION1)
(OPTION2)
SOL POWER
(OPTION4)
(OPTION5)
(OPTION3)
POWER OUT
P-1463
VU
I/O
RS232C/RS485
L1 L2 L3 PE
⑥
⑦