How To Select the Trip Point Action Cha
ter Four: O
eration
48
The board silkscreening defines the jumper positions. TH indicates that the trip point will
be on when the pressure is above the trip point, and TL indicates that the trip point will
be on when the pressure is below the trip point.
7.
Slide the enclosure over the unit and press it in place.
8.
Attach the hex nuts, removed in step 3, to the I/O connector.
9.
Reconnect the leads and wires.
10.
Attach the hex nuts, removed in step 3, to the I/O connector.
11.
Reconnect the leads and wires.
To Next Page
