www.mobotix.com • sales@mobotix.com
• By factory default, the MOBOTIX camera's
event control is disabled. Click on the button to activate event control.
This will activate video motion detection and recording. Cameras with integrated
flash memory (MOBOTIX R models and models with SD card) will use the flash
memory by default to store the image and video data (recording target). If desired,
you can set additional events and adjust the settings of the recording and storage
parameters (, and Admin
).
=> (
Software Camera Manual Part 2
, Chapter 7 and Chapter 8)
•
Upon detecting an event, the MOBOTIX camera can trigger
alarms. These alarms can be adjusted to your needs and you can assign them to
one or more events: playing back an alarm sound on the camera speaker, showing
the visual alarm in the camera live image, sending an e-mail or network message
with the alarm image, placing a phone call, uploading an alarm image to an FTP
server, switching a signal output line of the camera (for example, for switching on the
lights/opening a door). To change the corresponding settings, refer to the following
dialogs: , and and
.
=> (
Software Camera Manual Part 2
, Chapter 7)
To Next Page
Loading...
