Mobotix M24M - 2.6 Mounting The Camera With Pole Mount




www.mobotix.com • sales@mobotix.com


If you are intending to mount the camera on a pole, you should consider using the MOBOTIX
M24M Pole Mount. This mount is made of 3mm powder-coated stainless steel (white) and
has been designed specifically for outdoor use. The supplied stainless steel straps allow
the mount to be attached to poles with diameters between 60mm and 180mm (2.4in to
7.1in). By design, the pole mount does not allow the use of a flush-mounted wall outlet.
The camera is always installed together with the VarioFlex mount, which has been prepared
at the factory for wall mounting and therefore can also be secured directly to the pole
mount. The best camera position for the selected lens must be found before mounting
the camera (see Sections 1.2 and 1.5). Once the camera has been mounted to the wall,
you can fine-tune its position.
. See Section 3.9.1