www.mobotix.com • sales@mobotix.com
Required Tools
Please first check that all components supplied with the camera are present in the original
packaging (see Section 2.2).
The following additional tools are required for installation:
• Screwdriver
• for screw anchor holes
• MOBOTIX (at the end of this manual)
• Scissors to cut out the template
• to mark the drill holes
•
Materials and any tools needed to connect the pre-installed MOBOTIX network cable
in the camera with the on-site network cable
Caution
Never use to install the VarioFlex mount as these
screws will destroy the mount.
To Next Page
Loading...
