Mocon AMETEK Dansensor MAP Check 3 Vacuum - Device connections

20 User Guide EN Dansensor® MAP Check 3 Vacuum
P/N 320598-G
11/2019
Device connections
 Connect the long hose of the sample gas probe  to the “SAMPLE GAS INLET” connector.
See "Sample gas probe" on page 21 for further details.
 Connect the vacuum hose  to the “VACUUM” connector. Connect the other end to the
packaging machine’s vacuum system using the 1/4” RG hose fitting
 and the nylon
gasket
.
 On “Buffer” versions connect the supplied buffer gas hose  to the “BUFFER GAS INLET”
inlet connector simply by pushing the hose into the fitting as far as it goes.

See "7. Technical Information" on page 83 for details about the required pressure range.
See "Connection to buffer tank" on page 22 for further details about making a proper
connection to the buffer tank.





."1$IFDL7BD0$0