Mocon AMETEK Dansensor MAP Check 3 Vacuum - Connection to buffer tank

22 User Guide EN Dansensor® MAP Check 3 Vacuum
P/N 320598-G
11/2019
Connection to buffer tank
(“Buffer”versions only)
The device is delivered with a hose and fittings for making a proper connection to the buffer
tank. There are various ways to make the connection but we recommend any of the methods
described below.
 Sample hose (3m) with quick-connector
The hose can be shortened if required.
 Male quick-connector M5
 Nylon gasket
 T-fitting (not supplied)
CAUTION! When cutting hoses, ensure a clean and square cut (use a sharp knife
instead of cutting pliers).
1
MAP Check 3 Vacuum
Packaging machine
Gas Supply
Packaging machine
Gas Supply
(Not supplied)
BUFFER
TANK
BUFFER
TANK
2
2
3
3
4