Mocon AMETEK Dansensor MAP Check 3 Vacuum - Menus and Settings; General; Main menu

Dansensor® MAP Check 3 Vacuum EN User Guide 53
P/N 320598-G
11/2019
5. Menus and Settings
General
When device is switched on (after power off ) it is locked in User access level. In User access
level the operator has access to a limited number of functions only and is not allowed to
perform parameter setup.
To obtain full access you have to change the device to Supervisor access level.
See "Access level" on page 70 for details.
Main menu
Pressing the Menu key from the measuring screen brings up the Main menu
From the Main menu you can select the following submenus:
Product menu
1
Create, edit and delete products.
Display and delete logged product data.
See "Product menu" on page 54 for details.
Data log View logged data for currently selected product.
See "Data log" on page 58 for details.
Diagnostics menu Display device’s internal parameters and error diagnostics.
See "Diagnostics menu" on page 59 for details.
General setup
1
Setting of various device parameters.
See "General setup" on page 60 for details.
Access level Selection of access level for User, Supervisor and Service.
See"Access level" on page 70 for details.
Calibration
2
Calibration of sensors - for Service Technicians only.
25: Meat Mix 1000gr.
12:37
28/03/11
Ready
Cycles
263
12:37
28/03/11
CO
2
Bal
O
2
%
%
Data
log
Product menu
Diagnostics menu
General setup
Access level
Calibration
Export / Import
Language
Main menu
Faults
disabled!