Mocon AMETEK Dansensor MAP Check 3 Vacuum - Data Log Setup

Dansensor® MAP Check 3 Vacuum EN User Guide 63
P/N 320598-G
11/2019
Data log setup
Selecting Data log setup from the General setup menu will display a screen showing the
parameters for the data logging function.
Log interval Set the number of cycles for which the device should log data.
If set to 1, data is logged for all cycles.
Log all alarms No Alarms occurring in the period between logs
as set in "Log interval" are not logged.
Ye s All alarms are logged.
Logging enabled No No logging of data
Ye s Logging of data enabled
Logging mode Last values Ring buffer of specified number of log entries.
Normally this is best setting for On-Line
equipment due to the continuous operation.
Until memory full Logs data until memory is full, then stops
logging until data has been exported and/or
deleted.
Log last values Set number of log entries in the data log ring buffer
(Only appears when “Logging mode” is set to “Last values”)
Network logging Select whether or not network logging is required.
No No network logging
Ye s Network logging enabled
(Below parameters only appears when “Network Logging” is set to
“Yes”).

Network logging Select required data logging output format:
mode Compatible (Default)
Data format as used on devices
with firmware versions < 4.2.0.
See table on page 65.
Advanced New data format with more
information and many new
values.
See table on page 66.
Server IP Set up an IP-address to be used for collecting
log data for each measurement via LAN.
This requires for setting up of a Server Port
number as well.
%BUBMPHTFUVQ %BUBMPHTFUVQ
-PHJOUFSWBM
-PHBMMBMBSNT
-PHHJOHFOBCMFE
-PHHJOHNPEF
-PHMBTUWBMVFT
/FUXPSLMPHHJOH
/FUXPSLMPHHJOH
/FUXPSLMPHHJOHNPEF
4FSWFS*1
4FSWFS1PSU
"DLOPXMFEHF
%JTBCMFOFUXPSLFSSPST
DZDMFT
:FT
:FT
-BTUWBMVFT

/P
:FT
$PNQBUJCMF



/P
/FUXPSLMPHHJOH/P /FUXPSLMPHHJOH:FT