Dansensor® MAP Check 3 Vacuum EN User Guide 21
P/N 320598-G
11/2019
Sample gas probe
The sample gas probe leads the measuring gas from the measuring point of the packaging
machine’s die to the device. The gas probe consists of a 3 m long hose with a filter. The hose
can be shortened if required.
CAUTION! When cutting hoses, ensure a clean and square cut (use a sharp knife
instead of cutting pliers).
Connect the long hose to the device’s sample gas inlet.
Connect the other end to the packaging machine’s sample gas outlet using the delivered 1/8”
RG hose fitting
and the nylon gasket .
CAUTION! The performance of the device depends very much on the gas
extraction point on the packaging machine.
Contact MOCON Europe A/S for help to positioning the gas extraction point.
If the filter or hoses are blocked, the device will indicate an error in the display.
The filter should be replaced regularly - see "Replacing filter in the sample gas probe" on page 45
for details.
To Next Page
Loading...
