Mocon AMETEK Dansensor MAP Check 3 Vacuum - Electrical connections

Dansensor® MAP Check 3 Vacuum EN User Guide 23
P/N 320598-G
11/2019
Electrical connections
 Connect the power supply cable  between a power outlet and the “POWER” connector.
(The power cable is delivered with the device).
See pin connections for the power connector in "Power connector" on page 24.
 Connect a 25-pole communication cable  from the “I/O CONTROL” connector to the
appropriate port on the packaging machine. This cable is delivered with the device.

See cable specifications in "I/O Cable" on page 24.
 Connect a 9-pole serial cable  from the “COM1” connector to the appropriate port on the
packaging machine - see
"I/O signals for machine control" on page 27 for details.
This cable is not delivered with the device.
 Connect a 9-pole serial cable  from the “COM2” connector to the “COM1” connector on
the MAP Mix Provectus (option) - see
"I/O signals for machine control" on page 27 for details.
This cable is not delivered with the device.
 Connect a LAN/Ethernet cable  from the LAN connector (labelled ) to a connector on
your local area network. This cable is not delivered with the device.
NOTE! Use CAT6 cables for optimal noise immunity.

 The USB connector (labelled ) can be used for connecting a USB Memory stick  for
exporting/importing log data, device settings etc.
On “Stand-Alone” versions you can use the USB connector on the device front as well.



86%
*%



."1$IFDL7BD0$0