Mocon AMETEK Dansensor MAP Check 3 Vacuum - External Mixer Settings

Dansensor® MAP Check 3 Vacuum EN User Guide 61
P/N 320598-G
11/2019
Request ID when changing When set to “Yes” the operator will be prompted to enter
product some kind of information ex. product batch no. when
selecting a new product.

The text will be part of the logged data for each measurement.
Backlight Adjust display background light (1-10)
Contrast Adjust display contrast (1-10)
Brightness Adjust display brightness (1-10)
The “Backlight", "Contrast" and "Brightness" items are all
related to the display readability. Selecting each setting brings
up a new window where value can be set from 1 to 10.

Setting impact is seen while adjusting.
Formats/Units/Time Opens the Formats/Units/Time screen
See "Formats/Units/Time" on page 69 for details.
Supervisor PIN code setup Setting up the four-digit PIN code required for changing from
User access level to Supervisor access level.

(See "Access level" on page 70 for details).
External mixer settings
Selecting External mixer settings from the General setup menu will display a screen
showing the setup parameters for an external MAP Mix Provectus mixer connected to the
COM2-port of the

MAP Check 3 Vacuum.
External mixer No No mixer connected
connected Yes Mixer connected
- Gas 1 - Media Media connected to “GAS IN 1” on
mixer
- Gas 1 - P Low alarm Lower pressure alarm for Gas 1
(Setting to 0 will disable alarm)
- Gas 2 - Media Media connected to “GAS IN 2” on
mixer
- Gas 2 - P Low alarm Lower pressure alarm for Gas 2
(Setting to 0 will disable alarm)
- Gas 3 - Media Media connected to “GAS IN 3” on
mixer
- Gas 3 - P Low alarm Lower pressure alarm for Gas 3
(Setting to 0 will disable alarm)
External mixer tings
set