Mocon AMETEK Dansensor MAP Check 3 Vacuum - Replacing Air Inlet and Outlet Dust Filters

Dansensor® MAP Check 3 Vacuum EN User Guide 47
P/N 320598-G
11/2019
Replacing air inlet and outlet dust filters
CAUTION! Clogged air inlet and outlet filters can lead to overheating of the device.
Therefore they should be replaced or cleaned regularly, especially when device is
used in a dusty environment.

To replace the air filters do the following:
 Release the ventilation grille .
TIP! If grille does not come off easily, you can use a screwdriver  or the like to release it. 
 The filter  is located inside the grille. You can choose to replace both the grille  and the
filter
 or only the filter .
CAUTION! Never remove the screws  from the inside grille as they also hold the
fan inside the device.

1
3
4
2