Mocon AMETEK Dansensor MAP Check 3 Vacuum - System leak test

50 User Guide EN Dansensor® MAP Check 3 Vacuum
P/N 320598-G
11/2019
System leak test
This test is used to verify system tightness in sensor and flow parts. A leak is fatal for
measurements and the test should therefore be done periodically or in case of strange
readings.
 Apply vacuum to the device and stop the packaging machine.
 Enter Diagnostics and go to page 2 and select System leak test in the menu.
 A popup window will remind you to stop machine and to ensure that vacuum is applied.
Press Ye s to continue or No to cancel.
 The test will start with a short stabilizing period then a 1 minute measurement is
performed.
Yes
No
System leak test