Dansensor® MAP Check 3 Vacuum EN User Guide 39
P/N 320598-G
11/2019
Error/Warning list
Please note that messages marked with an asterisk (*) does not pop up on the screen. These
messages only appear as entries in the Error log - see
"Diagnostics menu" on page 59 for details.
No. Type Message User action
0 Error Unknown error has occured Re-start unit
If error persists,
contact service
1 Warning No products were found, a product with default
values was created
User information
2 Warning Too many products were found, some products
were deleted
User information
3 Error Error deleting product Try again
If error persists,
contact service
4 Error Internal error handling the products Contact service
5 Error Error changing active product Contact service
6 Error Error reading product from database Contact service
7 Error Error writing product to database Contact service
8 Warning Error adding product - product with this name
already exists
User information
9 Warning Product corrupt - replaced with default parameters User information
10 Error No such product found Contact service
12 Error Internal user interface error Contact service
13 Error Error opening LCD driver Contact service
14 Error Changing LCD contrast failed Contact service
15 Error Changing LCD brightness failed Contact service
16 Error Changing LCD backlight failed Contact service
17 Error Setting LCD to standby failed Contact service
18 Error Could not detect keyboard layout file. External
keyboard or scanner may not work correctly
Contact service
20 Error Internal data logging interface error Contact service
21 Error Data logging IO error Contact service
22 Error Data logging module is shut down Contact service
23 Warning Internal memory full. Data logging stopped User information
24 Error Could not detect USB memory stick. Please check if
the memory stick is correctly connected
User information
25 Error Import/Export: copy failed User information
To Next Page
Loading...
