Dansensor® MAP Check 3 Vacuum EN User Guide 75
P/N 320598-G
11/2019
6. PuTTY Terminal Server
The PuTTY Terminal Server program enables you to change the device’s configuration
parameters.
Even though the program can be used with any Dansensor® MAP Check 3 Vacuum model, it
especially applies to the “Black Box” models, as this is the only way to connect to these
devices.
The program file is on the Software CD that comes with the devices, and before using it you
should install it from here to the computer from where you wish to connect to the device.
To do so insert the CD in your computer, wait for the application to start and then follow the
directions.
Preparations
Before starting the program your device must be switched on and connected to your
computer by connecting an
RS232 (D-SUB 9) “Null modem” cable between a free COM-port
on your computer and the “COM 2” connector on the device (see
"Electrical connections" on
page 23 for details).
Configuration and Use
Initial configuration
To start the program simply double-click the PuTTY shortcut icon on your desktop.
The application starts showing the configuration window.
To Next Page
Loading...