Mocon AMETEK Dansensor MAP Check 3 Vacuum - Measuring

32 User Guide EN Dansensor® MAP Check 3 Vacuum
P/N 320598-G
11/2019
Start up
“Black Box” models
 When power is applied to the unit, the indicator on the front will be lit.
 After a short internal self diagnosis the device will start heating up the sensors. During this
period the indicator will turn red (steady).
 When heating period has finished the indicator will change to green (steady) and the
device is now ready for use.
Display models
 When first powered ON the display will shortly show the
Dansensor® MAP Check 3 Vacuum splash screen.
 After a short internal self diagnosis the device will start heating up the sensors.
During this time the “Measure” button will be disabled. If device is set to ”Autostart” it will
automatically start when heating period finishes.

While heating, you can go to the Main menu by pressing the Menu key - see "Main menu"
on page 53 for details.
25: Meat Mix 1000gr.
MeasureMenuProduct
12:37
28/03/11
Heating
Time left 07:43