Dansensor® MAP Check 3 Vacuum EN User Guide 81
P/N 320598-G
11/2019
In the General setup section you have access to the various settings in the device.
For information about the various settings and their influence please see "General setup" on
page 60.
To disable the connection to the device select Close terminal server from the Main menu
and then press Enter to confirm.
This will end the session and return the device’s COM2-port setting to PBI protocol.
The program window will change to show
To reestablish the connection to the device press F1 several times.
To close the program press the X button in the window’s upper right corner.
To Next Page
Loading...
