FlexStation 3 Benchtop Multi-Mode Microplate Reader User Guide
76 0112-0127 B
5. Make sure that the serial comm speed is 9600 Baud.
If you have correctly configured the settings in the Preferences
dialog as described in
Step 3 through Step 5 and you are still
observing problems (a red ‘X’ over the Flex icon, no temperature
in the temperature display box, or other problems), then you
must take further steps to establish communication between the
computer and the instrument, or to resolve a different
instrument problem. See Troubleshooting Procedures on
page 129.
6. The SoftMax Pro application defaults to Flex mode every time
you start the software. You can confirm this mode, if desired, by
clicking Control > Instrument Setup or click the Settings button
on the Plate section tool bar to view the Instrument Settings
screen.
Figure 3-11: Settings Button
Figure 3-12: Instrument Settings Dialog
Note: After you read an assay plate in Flex mode, the serial
communication speed changes to 57600 Baud.
FlexStation_manual.book Page 76 Tuesday, June 25, 2013 10:22 AM
To Next Page
Loading...
Need help?
General