Moneris Core Wireless Move/5000 - Battery Management and Usage; Charging and Status Indicators; Powering On and Stand-by Mode

Moneris Core® Move/5000: Using Your Terminal 12
Battery use
To maintain battery charge, use any method below:
 Direct-to-terminal charge cable: Connect this cable to the power port on the side of the terminal and plug
the other end into a working power outlet.
 Charge base: Dock the terminal on the optional charging base.
If needed, refer to the Move/5000 Setting up Your Hardware guide at moneris.com/support-move5000.
Helpful hints
 Check the battery charge level (see icons below) before use.
 Power off the terminal when not in use or being charged.
Battery status indicators
The battery icon displays in the status bar. The icon reflects the battery charge status/charge level.
Terminal connected to external power source
The "lightning bolt" portion of the battery icon appears when the
terminal is connected to an external power source.
Battery charge level
The coloured bars blink (one level at a time) when the battery is charging.
100%
charge
or less
75%
charge
or less
50%
charge
or less
25%
charge
or less
0%
charge
25% charge or less: Recharge the battery as soon as possible. The terminal may power off. Data will not be lost if
this happens.
0% charge: The terminal will power off unless connected to a power source. Data will not be lost if the
terminal powers off.
Stand-by mode
The terminal goes to the idle screen when it has not been used for a set time period. To exit this screen, press
any key and respond to any security prompts that appear, for example, “Enter your clerk ID”.
Power on
To power on the terminal, press and hold the green key until the screen illuminates.