Moog MSD Specification

SpecificationTWINsync module
2
ID no.: CB08759-001Date: 03/2023
moog
Series Model
Hardware version Firmware version
MSD Servo Drive
Single-Axis System
G392-xxxxx4xxxxx
G395-xxx-x4xxxxx
up to ...3.xxxx.0
up to ...3.xxxx.0
up to V2.15 / V201.07 / V230.00
MSD Servo Drive
Multi-Axis System
G393-xxx-x4xxxxx
G397-xxx-x4xxxxx
up to ...3.xxxx.0
MSD Servo Drive
Compact
G394-xxx-x4xxxxx
up to ...3.xxxx.0
Specification Option 2 - Technology
TWINsync option
ID no.: CB08759-001 Rev. 1.2
Date: 03/2023
This documentation is applicable to:
NOTE
This document is not a substitute for the MSD Servo Drive Operation
Manual. Please be certain to observe the information about “Measures for
Your Safety”, “Intended Use” and “Responsibilities” which can be found in
the operation manual. Information about installation, connections,
commissioning and promised technical specifications for the MSD Servo
Drive series can be found in the additional documents (Operation Manual,
Device Help, etc.).
Legal information
Subject to technical change without notice.
This Specification has been prepared based on DINEN82079-1. The content was
compiled with the greatest care and attention and reflects thelatest information
available to us.
We should nevertheless point out that this document cannot always be updated in
line with ongoing technical developments in our products.
Information and specifications may be subject to change at any time. For information
on the latest version please visit https://www.moogsoftwaredownload.com/msd.html.
Copyright ©
The entire contents of this documentation, especially the texts, photos and graphics it
contains, are protected by copyright. The copyright is owned by Moog unless
specifically marked otherwise.

Moog MSD Specifications

General

Brand	Moog
Model	MSD
Category	Servo Drives
Language	English