Moog MSD - Table of contents

Specification TWINsync module
3
Table of contents
ID no.: CB08759-001Date: 03/2023
moog
Table of contents
Table of contents
3
2 The TWINsync technology option
8
2.1 Hardware requirements
9
3 Installation
10
103.1 TWINsync connecting cable pin assignment
3.2 TWINsync connecting cable technical data 11
4 Description of parameters
12
4.1 General parameters of the TWINsync communication interface
12
14
14
14
15
16
4.1.1 Master/Slave Selector (P 2614) TOPT_TWIN_Mode
4.1.2 Timeout monitoring for the communication
4.1.3 Structure of a TWINsync data telegram
4.1.4 Configuration of the process data in the standard-mapping mode
4.1.5 Configuration of the process data in the extended-mapping mode
4.1.6 Scaling of the process data
16
18
4.2 Parametrization of the TWINsync master axis
4.3 Parametrization of the TWINsync slave axis
18
5 Control via TWINsync
20
6 TWINsync operation modes
22
22
6.1 Virtual encoder
6.2 Selection via parameter (P2580) MPRO_TWIN_Setting
22
23
24
28
31
32
6.2.1 User-specific mapping
6.2.2 TWin Drive profile “TWD” (speed)
6.2.3 Speed and position control
6.2.4 Double inverter "DI"
6.2.5 Rack-and-Pinion Drive Control "RPDC"
6.2.6 Virtual encoder “VE” (torque)
34
6.2.7 dSPACE TWINsync (rapid-prototyping systems from the Fa. dSPACE company) 35
6.2.8 Interpolating positioning “IP” 36
36
36
37
39
40
6.2.9 MSD PLC control "PLC"
6.2.10 Position setpoint (position reference value)
6.2.11 Serial Double Inverter "SDI" / Parallel Double Inverter "PDI"
6.2.12 Gantry application
6.2.13 Extended Mapping Mode
6.2.14 Dual Stator Winding motor "DSW"
42
7 Monitoring functions / Error messages 44
8 Index 45
1 General information
4
1.1 Target group
1.2 Requirements
1.3 Applicable documentation
1.4 Pictograms
1.5 Exclusion of Liability
1.6 Support
6
Legal information
2
4
4
4
5
5