Morgana CT620Exa - SETUP FOR OPERATION; How to set the paper feed tray

16
6. SETUP FOR OPERATION
ع
How to set the paper feed tray
Insert the edge of the feed tray guide at an
angle below the inner locator pin at the inser-
tion slot so that the green label of the feed
tray guide lines up with the green label on the
insertion slot (see drawing).
1.
2.
3.
4.
Set so that the groove on the feed tray guide
lines up with the outer locator pin.
If set correctly, the lower edge of the mark for
the (paper) feed unit clamp position on the
main unit side will match the feed tray inser-
tion slot position.
Set the paper feed tray rear edge clamp on
the feed tray.