Motorola LI2208 - Page 333

STANDARD DEFAULT PARAMETERS A - 3
Caps Lock Override Disable 6-8
Function Key Mapping Disable 6-9
FN1 Substitution Disable 6-9
Send and Make Break Send 6-10
User Preferences
Set Default Parameter Set Factory Defaults 7-4
Report Software Version N/A 7-5
Parameter Bar Code Scanning Enable 7-5
Beep After Good Decode Enable 7-6
Decode Illumination Indicator Disable 7-6
Beeper Tone Medium 7-7
Suppress Power Up Beeps Do Not Suppress 7-8
Beeper Volume High 7-8
Beeper Duration Medium 7-9
Hand-Held Trigger Mode Level 7-10
Hands-Free Mode Enable 7-11
Linear Imager Picklist Mode Auto-discriminate 7-12
Aiming Illumination Pulsing Pattern 7-13
Low Power Mode Enabled 7-14
Time Delay to Low Power Mode 1 Hour 7-16
Time Delay to Presentation Sleep Mode 5 Min 7-17
Continuous Bar Code Read Disable 7-19
Unique Bar Code Reporting Enable 7-19
Decode Session Timeout 9.9 Sec 7-19
Timeout Between Decodes, Same Symbol 0.5 Sec 7-20
Timeout Between Decodes, Different Symbols 0.1 Sec 7-20
Decoding Illumination Enable 7-21
Miscellaneous Options
Transmit Code ID Character None 7-22
Prefix Value 7013 <CR><LF> 7-23
Table A-1 Standard Default Parameters Table (Continued)
Parameter Default
Page
Number
1
User selection is required to configure this interface and this is the most common selection.