Getting Started 1 - 9
Performing a Clean Boot
A clean boot resets the MC45 to the factory default settings. All data in the Application folder is retained. You
must download the Clean Boot Package file from the Support Central web site
(http://supportcentral.motorola.com
) and install on the MC45.
To perform a clean boot:
1. Download the Clean Boot Package from the Support Central web site (http://supportcentral.motorola.com).
Follow the instructions included in the package for installing the package onto the MC45.
2. Simultaneously press the Power button and the 1 and 9 keys.
3. Immediately, as soon as the device starts to boot and before the splash screen is visible, press and hold
the right programmable button.
4. Insert the MC45 into a powered cradle.
5. The MC45 updates and then re-boots.
6. Calibrate the screen.
Waking the MC45
The wake-up conditions define what actions wake up the mobile computer after it has gone into suspend
mode. The mobile computer can go into suspend mode by either pressing the Power button or automatically by
Control Panel time-out settings. These settings are configurable and the factory default settings are shown in
are subject to change/update. To change the wake-up conditions, tap Start > Settings > Power > Wakeup.
Figure 1-9
Power Wakeup Tab
CAUTION A clean boot should only be performed by an authorized system administrator. You must connect the
MC45 to AC power during a clean boot.
Removing AC power from the MC45 during a clean boot may render the MC45 inoperable.
NOTE The right programmable button is mapped to Camera by default. The key can be remapped.