Motorola MC45 Integrator Guide

Specifications B - 3
SMS Cell Broadcast
To locally enable or disable the Cell Broadcast feature. Cell Broadcast is one-to-many geographically focused
service.
Using a registry editor, navigate to the following:
[HKEY_LOCAL_MACHINE\Software\Motorola\SMS_CB]
Edit the following key:
“Enable” = dword:1
where:
dword:0 = disabled
dword:1 = enabled (default).
Auto WAN Configuration
Auto WAN configuration is enabled by default but can be disabled via registry key:
Using a registry editor, navigate to the following:
[HKEY_LOCAL_MACHINE\SOFTWARE\Symbol\WWANService]
Edit the following key:
“EnableAutoNetworkSelection”=dword:0
where:
dword:0 = Disable Auto WAN configuration
dword:1 = Enable Auto WAN configuration
Multi Tap Timing
By default the multi tap timing when in alpha mode is set to 600 ms. In order to change the multi tap timing use
the following registry key. Keep in mind that the timing is in milliseconds.
Using a registry editor, navigate to the following:
[HKEY_LOCAL_MACHINE\Drivers\BuiltIn\keypad]
NOTE The absence of a value shall default to “Enabled”. Please reboot 2 times after setting the Enable registry
to make sure the SMS Cell Broadcast setting takes effect. It has been observed that the power
consumption in standby mode is higher on some networks(e.g: AT&T and AirTel/BGL) with SMS Cell
Broadcast enabled. Disabling SMS Cell Broadcast will reduce the power consumption.
NOTE Auto WAN configuration can also be disabled by placing a file named “DisableAutoNetworkSelection”
into the root directory of the SD Card. This SD Card must be present at boot up.

Motorola MC45 Specifications

General

Brand	Motorola
Model	MC45
Category	PDA
Language	English