Maintenance & Troubleshooting 7 - 11
Four Slot Battery Charger
Cables
Table 7-5
Troubleshooting the Four Slot Battery Charger
Problem Cause Solution
LEDs do not light
when MC45 is
inserted.
Charger is not receiving
power.
Ensure the power cable is connected securely to both the
charger and to AC power.
MC45 battery is not seated
firmly in the charger.
Remove and re-insert the MC45 battery into the charging
well, ensuring it is firmly seated.
MC45 battery is not
charging.
Battery was removed from
the charger or charger was
unplugged from AC power
too soon.
Re-insert the battery in the charger or re-connect the
charger’s power supply.
Battery is faulty. Verify that other batteries charge properly. If so, replace
the faulty battery.
Battery contacts not
connected to charger.
Verify that the battery is seated in the charging well
correctly with the contacts facing down.
Ambient temperature of
the cradle is too warm.
Move the charger to an area where the ambient
temperature is between 0°C (32°F) and 35°C (95°F).
Table 7-6
Troubleshooting the Cables
Problem Cause Solution
MC45 battery is not
charging.
MC45 was disconnected
from AC power too soon.
Connect the power cable correctly. Confirm main battery
is charging under
Start
>
Settings
>
Power
.
Battery is faulty. Verify that other batteries charge properly. If so, replace
the faulty battery.
The MC45 is not fully
attached to power.
Detach and re-attach the power cable to the MC45,
ensuring it is firmly connected.
During data
communication, no
data transmits, or
transmitted data was
incomplete.
Cable was disconnected
from MC45 during
communications.
Re-attach the cable and retransmit.
Incorrect cable
configuration.
See the system administrator.
Communication software
is not installed or
configured properly.
Perform setup as described in
Communication Setup on
page 2-18
.
To Next Page
Loading...
Need help?
General
