Motorola MT2070 - Page 532

A - 2 MT2070/MT2090 User Guide
Parameter Broadcast (Cradle Host Only) Enable 4-19
Pairing Modes Unlocked 4-20
Pairing on Contacts Disable 4-20
Connection Maintenance Interval 15 min 4-23
Authentication Disable 4-26
Variable Pin Code Static 4-27
Encryption Disable 4-28
User Preferences
Set Default Parameter Set Defaults 5-4
Host Mode Cable Priority 5-5
Decode Pager Motor Enable Disable 5-6
Parameter Bar Code Scanning Enable 5-7
Scan Angle Wide 5-8
Adaptive Scanning Enable 5-9
Adaptive Scanning
Interference Suppression Mode
Ambient Light Interference
Suppression Auto Detection
5-10
Adaptive Scanning
Interference Suppression Scan Angle
Wide 5-11
Beep After Good Decode Enable 5-12
Beeper Tone Medium 5-13
Beeper Volume High 5-14
Hand-Held Trigger Mode Standard (Level) 5-15
Picklist Mode Disabled Always 5-16
Decode Session Timeout 9.9 Sec 5-15
Timeout Between Decodes, Same Symbol 0.5 Sec 5-17
Hand-Held Decode Aiming Pattern Enable 5-17
Decoding Illumination Enable 5-18
Batch Mode No Batch Mode 5-19
FIPS Mode Disable 5-21
Table A-1 Standard Default Parameters Table (Continued)
Parameter Default Page Number
1
User selection is required to configure this interface and this is the most common selection.