Motorola MT2070 - Page 533

Standard Default Parameters A - 3
DPM Scanning (MT2070-DP only) Enable 5-21
Miscellaneous Options
Transmit Code ID Character None 5-22
Prefix Value 7013 <CR><LF> 5-23
Suffix 1 Value
Suffix 2 Value
7013 <CR><LF> 5-23
Scan Data Transmission Format Data as is 5-24
FN1 Substitution Values Set 5-25
Transmit “No Read” Message Disable 5-26
Imaging Preferences
Operational Modes N/A 6-4
Image Capture Illumination Enable 6-5
Snapshot Mode Timeout 0 (30 seconds) 6-6
Snapshot Aiming Pattern Enable 6-6
Image Cropping Disable 6-7
Crop to Pixel Addresses 0 top, 0 left, 1023 bottom, 1279 right 6-8
Image Brightness (Target White) 180 6-9
JPEG Quality and Size Value 65 6-9
Image File Format Selection JPEG 6-10
Signature Capture Disable 6-11
Signature Capture Image File Format Selection JPEG 6-12
Signature Capture Width 400 6-13
Signature Capture Height 100 6-13
Signature Capture JPEG Quality 65 6-13
Video View Finder Disable 6-14
RS-232 Host Parameters
RS-232 Host Types Standard 8-6
Baud Rate 9600 8-7
Parity Type None 8-9
Table A-1 Standard Default Parameters Table (Continued)
Parameter Default Page Number
1
User selection is required to configure this interface and this is the most common selection.