6 - 10 Maintenance
7. Remove the two PCB screws using a T20 TORX driver.
Figure 6-7 Connector Clips, Accessory Connector and PCB Screws Removal
8. Lift the front edge of the transceiver board (the edge that mates with the Enhanced Control
Head), and pull it towards the front of the terminal. Take care to slide the antenna connector
and power connector out of the bottom die cast towards the front.
SIM Dust Cover Removal
1. Remove the dust cover screw using a Phillips screwdriver.
2. Remove the dust cover from the chassis.
Figure 6-8 SIM Dust Cover Removal
Reassemble the Terminal Chassis And Transceiver Board (torques, see page 6-6)
1. Inspect the bottom diecast and diecast cover for remnants from the transceiver main seal. If
necessary remove the remnants using isopropyl alcohol (100%) applied on a soft, absorbent,
lintless cloth or tissue.
2. Check the main seal and control head O-ring on the terminal for damage. Replace part if
damage is found (refer to the exploded view diagrams and part list).
PCB screws
To Next Page
Loading...
Need help?
General