• Duplex
• Simple
• Keypad
• Tones
• Call-Out
The Volume Control Mode is configurable using the Customer Programming Software (CPS).
NOTE: When a volume control capable Bluetooth device is connected, the radio always uses
the Common setting.
You can configure the maximum volume offsets (dB) and the volume range (dB) through CPS. The
field is Audio Settings→User Profile. The volume control in the radio is divided into 13 steps, from 0
to 14. If for example, the vol. range is set to 39, each step on the volume indication bar is 3 dB.
4.10.5.4.1
Setting Volume Adjustment Mode
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup→Audio→Volume Adj. Mode.
3 Select one of the following options:
• Individual – You can set Duplex, Simplex, Earpiece, Speaker, and Keypad per your
preferences in Menu→Setup→Set Volume.
• Common – You can set one value for all the items in Menu→Setup→Set Volume.
4.10.6
Tones
This field sets the volume level for the tones set.
NOTE: The radio has two tone packs: Classic Tones (default) and New Tones. Your service
provider decides which tone pack is enabled.
4.10.6.1
Keypad Tone
You can activate/deactivate keypad tone at every key press.
4.10.6.1.1
Setting Keypad Tone
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup→Tones→Keypad Tone.
3 Select one of the following options:
• On – Activates keypad tone.
• Off – Deactivate keypad tone.
MN006260A01-AG
Chapter 4 : Main Menu
117
To Next Page
Loading...
Need help?
General
