• Emergency Call
• Emergency Short Data Service (SDS) Status
• Location Information Protocol reports
3.5.14
Exiting Emergency Operations
Prerequisites: Make sure that your radio is engaged in Emergency Operations.
Procedure:
1 Perform one of the following actions:
• Press End if your radio displays Emergency Mic On.
• Press and hold Exit.
NOTE: Press the End key if an Emergency Operation triggered by Emergency
number (not by Emergency button) to exit the Emergency Operation.
Your radio exits Emergency Operations.
3.6
Repeater Mode
NOTE: This is a Software Selling Feature.
The Repeater Mode provides repeater connectivity between radios operating in the DMO Mode.
Figure 7: Repeater Mode Operation
When the radio is in DMO repeater mode, it extends the DMO range by retransmitting received
information from one radio to another. It retransmits group calls, private calls and data on a given
frequency. In the diagram, the radio in the middle serves as a repeater.
The repeater sends presence signal periodically on a free channel to allow other radios to synchronize
on a given frequency.
Only the radios on the same talkgroup can communicate with each other through the repeater.
The Repeater Mode is activated by selecting Menu→Networks→Repeater Mode.
MN006260A01-AG
Chapter 3 : Modes
75
To Next Page
Loading...
Need help?
General
